How to replace the brake pads: 1. Release the handbrake, you will need to change the brake wheel hub Loosen the screws (note that loosen the brake pads Hebei factory direct, do not completely screwed down). Top good car with a jack. Then remove the tires. Before moving brake brakes, best cleaned with a special brake fluid in the brake system sprays to avoid powder into the respiratory tract, affecting their health. 2. Remove the brake caliper screws (for some cars, as long as one twist, and then another to loosen) 3. Place the brake caliper with a rope hung Jiangsu factory direct brakes to avoid braking pipeline damage. Then remove the old brake pads. Both sides of each brake pad has a raised flag, this flag is about the thickness of twenty-three mm, which is the thinnest brakes replace the limit, if the thickness of the brake pads have parallel Hubei brakes factory direct sales with this flag, then must be replaced. Thus, when the thickness of the brake pads closer to the mark when the owner must always observe the ready, but without removing the tire is difficult to accurately observed by the naked eye, there are many models in the brakes too thin when the handbrake light meter position will be The tips, relatively self-test on convenience. Jiangxi brakes factory outlets | Chi Auto Parts (certified) | brakes Ltd. provided by Linyi Chi auto parts. Linyi Chi Auto Parts Co., Ltd. (www.zxqcpj. China) (www.zxqcpj. China) Shandong Linyi, brake shoes, pieces of leaders, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, the maximum to meet customer needs. Chi Heng Auto Parts in leadership with the staff warmly welcome all inquiries negotiations to create the Chi Heng Auto Parts a better future. You can also access (www.zxqcpj. China /supply_details_49290315.html), for more information about the company.